Thank you Christian!
I managed to obtain the results based on your advice.
Best regards,
Dennis
effect size (f2) and predictive relevance (Q2 and q2)
-
- PLS Junior User
- Posts: 9
- Joined: Mon Jul 16, 2012 8:30 am
- Real name and title:
Citation Needed
Michelle makes a point about q2 for complex models; where can I find a citation to justify that with a complex model I cannot apply the q² formula to calcualte the effect size of Q² , specially when you have several dependent variables?
Thanks,
Juan Carlos.
Thanks,
Juan Carlos.
-
- PLS Junior User
- Posts: 9
- Joined: Mon Jul 16, 2012 8:30 am
- Real name and title:
Hengky thanks again!!!
As always helping me out!!
-
- PLS Junior User
- Posts: 3
- Joined: Thu Jul 28, 2016 3:32 pm
- Real name and title: Levi
Re: effect size (f2) and predictive relevance (Q2 and q2)
Hi everybody,
did i understand it right, that now in SmartPLS 3 it is possible to look after the effect size (f2) and the cross validated redundancy (Q2) without calculating it by hand?
thanks :)
Holsteinerin22
did i understand it right, that now in SmartPLS 3 it is possible to look after the effect size (f2) and the cross validated redundancy (Q2) without calculating it by hand?
thanks :)
Holsteinerin22
-
- PLS Junior User
- Posts: 3
- Joined: Wed Aug 29, 2018 12:42 pm
- Real name and title: Mr.Suresh Acharya
Re: effect size (f2) and predictive relevance (Q2 and q2)
Can some one help
I am using Smartpls2 for a analysis pertaining to q2 (manual calculations) only. Here I find that SSO for calculating the Q2 is standard 3 times the number of samples. Though I have constructs with both 3 and 4 items. It considers only 3 items for all. But this is not true in SmartPLS3. The constructs with 4 items and 3 items the SSO are different, Why is this?
I am using Smartpls2 for a analysis pertaining to q2 (manual calculations) only. Here I find that SSO for calculating the Q2 is standard 3 times the number of samples. Though I have constructs with both 3 and 4 items. It considers only 3 items for all. But this is not true in SmartPLS3. The constructs with 4 items and 3 items the SSO are different, Why is this?