effect size (f2) and predictive relevance (Q2 and q2)

This forum is closed, and read-only.
vonbergh
PLS Expert User
Posts: 60
Joined: Tue Jan 26, 2010 10:06 pm
Real name and title:

Post by vonbergh »

Thank you Christian!
I managed to obtain the results based on your advice.
Best regards,
Dennis
juanclondono
PLS Junior User
Posts: 9
Joined: Mon Jul 16, 2012 8:30 am
Real name and title:

Citation Needed

Post by juanclondono »

Michelle makes a point about q2 for complex models; where can I find a citation to justify that with a complex model I cannot apply the q² formula to calcualte the effect size of Q² , specially when you have several dependent variables?

Thanks,

Juan Carlos.
User avatar
Hengkov
PLS Super-Expert
Posts: 1599
Joined: Sun Apr 24, 2011 10:13 am
Real name and title: Hengky Latan
Location: AMQ, Indonesia
Contact:

Post by Hengkov »

Hi,

I think no problem for calculate effect size and predictive relevance complex models. You can calculate it, but difficult because SmartPLS cannot compute it automatically. Using WarpPLS very easy for compute it. Hope developer SmartPLS for attention it next version.

Best Regards,
Hengky
juanclondono
PLS Junior User
Posts: 9
Joined: Mon Jul 16, 2012 8:30 am
Real name and title:

Hengky thanks again!!!

Post by juanclondono »

As always helping me out!!
Holsteinerin22
PLS Junior User
Posts: 3
Joined: Thu Jul 28, 2016 3:32 pm
Real name and title: Levi

Re: effect size (f2) and predictive relevance (Q2 and q2)

Post by Holsteinerin22 »

Hi everybody,

did i understand it right, that now in SmartPLS 3 it is possible to look after the effect size (f2) and the cross validated redundancy (Q2) without calculating it by hand?

thanks :)
Holsteinerin22
sunnyarch
PLS Junior User
Posts: 3
Joined: Wed Aug 29, 2018 12:42 pm
Real name and title: Mr.Suresh Acharya

Re: effect size (f2) and predictive relevance (Q2 and q2)

Post by sunnyarch »

Can some one help

I am using Smartpls2 for a analysis pertaining to q2 (manual calculations) only. Here I find that SSO for calculating the Q2 is standard 3 times the number of samples. Though I have constructs with both 3 and 4 items. It considers only 3 items for all. But this is not true in SmartPLS3. The constructs with 4 items and 3 items the SSO are different, Why is this?
Locked