blindfolding in smartpls 3.2.1
Posted: Thu Jun 04, 2015 8:56 am
hi,
I am not able to run blindfolding procedure, construct wise.
It is showing a basic setting having omission distance values. nothing else.
can anyone suggest, what can be done. I dont see this setting as mentioned/shown in the the primer on smartpls.
thank you
I am not able to run blindfolding procedure, construct wise.
It is showing a basic setting having omission distance values. nothing else.
can anyone suggest, what can be done. I dont see this setting as mentioned/shown in the the primer on smartpls.
thank you