forum.smartpls.com

Hello , after I run the PLS-Algorithm

Can someone tell me I should click on which of the menu settings to get regression output ?

I think the path coefficients are the closest to what you are looking for. It reports the regression results between the latent variables scores in the inner (structural) model.

Thanks for reply jmbecker , I see no one else reply so am still not sure about it

If you use path analysis with observed variabel then standardized path coefficient is same as standardized coefficient of Ordinary Least Square regression.

Mr.ghozali thanks for reply my question is can I use the path coefficient for hypothesis testing whether accepting or rejecting null hypothesis ?

for example in my picture
can I use regression weight to test my hypothesis ?

Hypothesis: behavioral factor influence positively intention to use ? since regression weight more than 0.05 we can accept the null hypothesis right ?!

Hi,

No. you must run bootstrapping and see the reuslt T-statistics or P-value (one/two tailed).

Regards,

Thanks Hengkov for reply, since my sample= 211
which settings I should use do I need to change anything ? , anyway I test I run it same as photo

Now since I get the T value as well as P value, if my p value is significance should I check also t value ? can you give me example from my data about hypothesis is correct , another example about hypothesis is not correct from the data in second photo.