Hello,
My question is related to change in R2 and how to test the significance of this change in SmartPLS.
My research design is related to testing the predictive power of leadership theories. The data was collected from one organization, and the same respondents have filled out measures for independent and dependents variables of the model (leader behavior and follower performance). The sample size is the same for all three model.
In order to test the predictive power of the model, I did following steps:
1) Run model A, B, and C independently, where model A, B represent two different leadership theories and model C is derived from interview data.
2) Reduce the models based on path coefficients, i.e. retain the variables which are significant or near significant.
3) Run the reduced models A, B, and C independently to make sure that the predictive power of model is consistent with the original model.
4) Run the reduced model A and add variables from model B to look at change in R2. Ran other possible combinations (Model (A+C), added model B etc.)
I have two questions -
a) Am I violating any assumptions by running only the reduced model?
b) How do I check for the significance of change in R2 in SmartPLS?
Thanks
Rita Palrecha
Change in predictive power of a model
Change in predictive power of a model
Rita Palrecha
- Diogenes
- PLS Super-Expert
- Posts: 899
- Joined: Sat Oct 15, 2005 5:13 pm
- Real name and title:
- Location: São Paulo - BRAZIL
- Contact:
Hi,
a) No, it is OK.
b) For the addition of q independent (exogenous) variables:
df = n - p - 1 and Delta_F = Delta_R2 * (n - p - 1) / (q * (1 - R2_last))
SmartPLS doesn't do this, you must compute by "hand".
see more details in the p.599 of SPSS 15.0 Algorithms available in https://www.washington.edu/uware/spss/docs/
Best regards
Bido
a) No, it is OK.
b) For the addition of q independent (exogenous) variables:
df = n - p - 1 and Delta_F = Delta_R2 * (n - p - 1) / (q * (1 - R2_last))
SmartPLS doesn't do this, you must compute by "hand".
see more details in the p.599 of SPSS 15.0 Algorithms available in https://www.washington.edu/uware/spss/docs/
Best regards
Bido
Predictive power of a model
Hello Professor Bido,
Thanks a lot for your reply.
Regards,
Thanks a lot for your reply.
Regards,
Rita Palrecha