Page 1 of 1

Copied and renamed models won't run

Posted: Tue May 28, 2013 2:26 pm
by spangler
Hi all,

Sometimes I copy a valid model such as "Model A," then I either use the automatic label "Copy of Model A," or I change the name, "Model B." In either case the new model (the old model with the new name) won't run and I get the message "There must be a valid pathmodel for calculation." Also now the original Model A won't run either, although Model A ran successfully before I made the copy. What can I do. i suspect the program doesn't recognize the model name after the copy has been made. Thanks in advance.

Posted: Sun Jun 02, 2013 1:07 pm
by Hengkov
Hi,
Please try select another folder for save your new model (after copy and change name) before ran again.

Regards,

Posted: Sun Jun 02, 2013 10:39 pm
by spangler
Hi Hengky,

Thanks for the info.