Page 1 of 1

Run model while omitting variables

Posted: Thu Apr 02, 2009 9:57 am
by Mars
Hi, Would be helpful if you can still run the model when you omit some paths, but don't have to delete the whole variable . The excluded variables would show up in red color anyway, so there is no way you could be mistaken. This provides a quicker way to do sensitivity checks, etc., without having to redraw part of the model afterwards.

Posted: Mon Apr 06, 2009 8:03 am
by alan_scott
If you delete the variables/paths you don't want in the model, then run it, you can inspect the results and then get those variables and paths back again with the <Undo> command, i.e. <ctrl> <z>. This way, you don't have to redraw part of the model.

Redrawing the model

Posted: Mon Aug 16, 2010 9:59 am
by dinessa
I just open a new editior from the current one. And then a copy of my model is shown. There I do the modifications I am interested in and calculate. If it is only a quick sensitivity check, I close the new editor window without saving.