Page 1 of 1
Multigroup analysis
Posted: Sun Oct 21, 2012 12:28 pm
by wissem
Hello
Please does someone know how to conduct a multigroup analysis with smartPLS?
Thanks a lot
Posted: Sun Oct 21, 2012 3:09 pm
by Hengkov
Hello,
For test multigroup using SmartPLS, used Non-parametric approach with bootstrap sample (5.000) or Smith Saterwaite Test.
Regards,
Hengky
Posted: Thu Oct 25, 2012 10:03 pm
by husseins
Salam Pak Hengky,
I have more than 2 groups that will be compared. I don't think smartPLS can be used to do multigroup comparison for more than group. I also tried XLStat, however, it seems this program also does not allow us to do multigroup comparison for more than 2 groups. Hence any ideas what program can be used? I
Thanks
Posted: Fri Oct 26, 2012 7:00 am
by Hengkov
Halo Ibu Ananda,
For compare more than 2 groups used OTG approach.
See:
Sarstedt, M., Henseler, J., and Ringle, C.M. 2011. “Multigroup Analysis in Partial Least Squares (PLS) Path Modeling: Alternative Methods and Empirical Result,” Advances in International Merketing (22:1), 195-218.
Sarstedt et al. (2011) compare three groups (France, Germany and USA).
But btw, this approach difficult.
Best Regards,
Hengky
Multi-group analysis: OTG vs. Kruskall Wallis Test
Posted: Sun Nov 18, 2012 8:24 am
by Barbara Stahl
Dear PLS community,
in order to run a comparison of more than two subgrups, OTG is recommended. However you also could use the bootstrapping outcomes for a Kruskal-Wallis test in SPSS for examples.
Are there any concerns about such a procedure?
Or why is OTG better?
Thanks for sharing your experience.
Best, Barbara
Where are the results for OTG in SmartPlS
Posted: Fri Feb 22, 2013 5:50 pm
by jkelley
Where to you find the results for the OTG approach in SmartPLS?
Posted: Wed Feb 27, 2013 6:15 pm
by Hengkov
Hello James,
SmartPLS cannot handle OTG, used R program.
Best Regards,
Hengky