forum.smartpls.com

I'm currently working on segmenting my data and thus do 10 calculations for each segment number that seems reasonable. With reasonable I mean average R² over the segments (I check the average and the by segment size weighted average) and the share of segments that are above the minimum number of ca...

I like to seek guidance on how to use the PLS-POS in SmartPLS 3.

Are there any papers published that show the exact detailed steps of using PLS-POS?

Please advise. Thank you.

I like to double check if we can run the non-response bias (early versus late respondents) by using the PLS-MGA? That is, I divide into two groups of data: early versus late. Then after running PLS-MGA, I look under the p value column to see if less than 0.05 or more than 0.95 to determine significa...

I refer to page 253 of the book... last 5 lines.

If resulting p value is lower than 0.05 or higher than 0.95, then we look at the values under Unequal Standard Errors Assumed (in the Excel PLS-MGA_Parametric.xlsx)?

Please advise. Thank you.

Yes fully support this initiative!

Thank you for your reply.

Let's hope the next software upgrade will include this feature.

Please refer to discussions at: viewtopic.php?f=5&t=3887

Please refer to Page 228... second last line from bottom...

The VAF equals the "direct effect" divided by the total effect...

It should be "indirect effect".

Thank you.

In SmartPLS 3, we can see the results of small f square.

However, is there a way to use SmartPLS 3 to generate results for small q square?

Thank you.

In Table 4.10 below, it shows the significance tests for the non-redundant vanishing tetrads from a bootstrapping procedure. In a reflective measurement model, the vanishing tetrads should be non-significant, and the resulting p Values should be higher than 0.05. However, as shown in the last column...

Dear Dr. Becker

Thank you so much for your enlightenment!!!

It certainly makes so much sense now!

Please help.

Anyone please give advice?

1. How to use the SmartPLS to determine whether a construct should be formative or reflective? => Please show the detailed steps in SmartPLS. 2. Results from SmartPLS are different from what is shown in: Gudergan, S.P., Wende, S. & Will, A., 2008. Confirmatory tetrad analysis in PLS path modelin...

praveen wrote:Sir
Most of the help available regarding tetrad analysis in the forum are prior to smartpls 3.

Can you please throw us some guidelines on tetrad analysis and interpretation using smartpls 3.

Thanking you
Praveen S
Doctoral Student

Yes I need help on this too!

Hi, It's easy, you only have to connect the endogenous variables to control variables that want to be controlled. Examples of the journal can be seen below http://www.sciencedirect.com/science/article/pii/S0959652614009664 To be clear, do you mean that we create a latent variable (to act as control...